Filter
Top Products
SATO M-5900RV Operator and Technical Reference Manual Page D-1
PN 9001081
Rev. C
Introduction
This section contains instructions for using the following M-5900RV optional
features:
Label Rewinder
Label Cutter
Label Dispenser
PCMCIA Memory Cards
Calendar
Label Rewinder
The rewinder is an external unit that allows for labels and tags to be rewound
in rolls up to 8.5 inches in diameter. It derives its power directly from the
printer's EXT connector using a built-in cable. The rewinder provides the
ability to rewind tags/labels from the printer and subsequently be unwound
for later use with applicators.
Installation
1. Position the Rewinder at the front of the printer and align it with the
label slot. The Rewind Wheel/Spindle should be positioned away from
the printer.
2. Connect the built-in cable from the Rewinder to the EXT connector at
the rear of the printer.
3. On the Rewinder, remove the metal clamp from the Rewind Spindle.
4. Feed the lead end of the label stock under the first spindle and onto the
Rewind Spindle. Feed the stock around the spindle once, then replace
the metal clamp over the label stock. Wind another revolution to
ensure the labels are secure on the spindle.
5. Select the REWIND option on the rewinder, then set the power switch
to ON. The printer must be powered ON for the rewinder to function.
Removing and Unwinding the Roll
As labels are printed, tension from the rewinder should keep the label
stock taut as it wraps itself on the spindle.
Optional Accessories
,
Appendix