Filter
Top Products
PN 9001081
Rev. C
SATO M-5900RV Operator and Technical Reference Manual
Page 2-20
Section 2. Installation and Configuration
2.10 Printer Adjustments
The LCD Panel on the M-5900RV is used in conjunction with the LINE and FEED switches by
the operator to manually enter printer configuration settings. Many of the settings can also be
controlled via software commands and in the case of conflict between software and control
panel settings, the printer will always use the last valid setting. If you load a label job that
includes software settings and then enter a new setting via the Operation Panel, the manually set
values will be used by the printer. If you set the values manually and then download a job with
software settings, the software settings will be used.
POWER ON
ONLINE
QTY:000000
USER TEST PRINT
SMALL LARGE
ADVANCED MODE
SETUP
DEFAULT SETTING
COMPLETED
USER DOWNLOAD
ONLINE
QTY:000000
ALT. PROTOCOL
DEFAULT COMPLETED
PRINT BUFFER
Hex Dump Label
RECEIVE BUFFER
Hex Dump Label
Page 2-21
Page 2-19
Page 2-36
Page E-2
Page E-2
Page 2-38
Page 2-38
Page 2-15
POWER
FEED+POWER
LINE+POWER
LINE+FEED+POWER
DSW2-7=ON +LINE+POWER
DSW2-7=ON +LINE+FEED+POWER
DSW2-8=ON+POWER
POWER
DSW2-4=ON+POWER
Normal/User Mode
User Test Print
Advanced Mode
Load SATO Default Settings
User Download Defined Protocol Codes
Reset to SATO Default Protocol Codes
Emulation Mode
Print Hex Dump Label
Print Hex Dump Label
Page 2-24