Filter
Top Products
PN 9001081
Rev. C
SATO M-5900RV Operator and Technical Reference Manual
Page 2-36
Section 2. Installation and Configuration
STEP PROCEDURE
Advanced Mode
Advanced Mode Counters (Cont)
head cntr clear
yes no
cut cntr clear
yes no
exit adv. mode
no yes
4. Press the FEED key again to advance to the Counter Clear display
(CNTR CLEAR). To clear the counter, (Note that the LIFE counter cannot
be cleared), press the the LINE key until the underline cursor is beneath
the YES; then press the FEED key to display the EXIT ADV. MODE. (Refer
to page 2-34) If you do not want to clear the counter, press the LINE key
until the underline cursor is beneath the NO. Then press the FEED key to
display the EXIT ADV. MODE.
2.12 Printing Test Labels
This option allows you to print a test label. It is recommended that you print a test label
after you have changed any of the settings in the Advanced Mode. The test label allows
you to verify that you indeed did make the desired changes.
STEP PROCEDURE
1. Power up the printer while pressing the FEED key and an audible
signal will be heard. Release the FEED key and the printer will display
the following message on the LCD panel.
2. Use the LINE key to step the underline cursor to either the Large or
Small selection. If Large is underlined, (the default position is Large) a
label will be printed for a maximum label width (4). Press the FEED
key to print the label which will contain a head check pattern and
current printer setting information. Press the FEED key again to pause.
Pressing the FEED key again will resume printing.
To enter the User Test Print:
user test print
small large