Filter
Top Products
PN 9001081
Rev. C
SATO M-5900RV Operator and Technical Reference Manual
Page 2-22
Section 2. Installation and Configuration
Printer Adjustments
There are four Speed settings on the printer. The setting is listed on the bottom
line of the display. The current setting is indicated by an underline under one of
the speed settings. To change the setting:
STEP PROCEDURE
1. Use the LINE key to step the underlined cursor to the desired
speed setting.
2 = 2 in/s (50mm/s)
3 = 3 in/s (75mm/s)
4 = 4 in/s (100mm/s)
5 = 5 in/s (125mm/s)
2. Once the correct setting is underlined, press the FEED key to
accept the setting and advance to the next adjustment.
Note: The setting can be overridden by software.
Print Speed Adjustment
PRINT speed
2 345
Pitch Offset and Direction
The label pitch is the distance from the leading edge, (the edge that comes out of
the printer first) of a label and the leading edge of the printing. The leading edge
position of the label can be adjusted relative to the print head +/- 49 mm in
increments of 1 mm using the following procedure. Once the position is set, it can
be adjusted +/- 3.75 mm using the PITCH potentiometer on the adjustment panel,
(see page 2-40).
MOVED WITH MINUS
(-) OFFSET
ORIGINAL PRINT LINE
MOVED WITH POSITIVE
(+) OFFSET
LABEL FEED
DIRECTION