Filter
Top Products
SATO M-5900RV Operator and Technical Reference Manual
Page 4-11
Section 4. Programming Reference
PN 9001081
Rev. C
COMMAND DEFAULT NOTE
Character Expansion 1 (1)
Print Darkness 2 (1)
Print Speed DSW2-8 On 6 ips (2)
Print Speed DSW2-8 Off 4 ips (2)
Proportional Spacing Enabled (1)
Cutter Command Disabled (1)
Print Rotation 0
0
(1)
Vertical Reference Point 0 (1)
Horizontal Reference Point 0 (1)
Character Pitch 2 (1)
Base Reference Point H=0, V=0 (2)
4.7 Command Default Settings
There are some types of commands that must have a value specified before a label
can be printed. If the data stream does not contain these commands, a "default"
value is assumed. The commands and the corresponding default values are:
NOTES:
(1) The settings for these commands will revert to the default value when the
printer receives an <ESC>Z or an <ESC>*.
(2) The values transmitted with these commands will remain in effect until a new
command is received.