Filter
Top Products
SATO M-5900RV Operator and Technical Reference Manual Page E-3
Appendix E. Custom Protocol Command Codes
PN 9001081
Rev. C
Download Procedure (Cont)
6. After the command has been sent, the unit will beep and print a status
label. If it does not beep and print the label, the printer did not accept the
data.
7. If the printer does not beep and print a setting label, turn the printer off,
check your download command stream for errors and correct if necessary.
Then start the download process over at Step 1.
8. If the custom codes are correct, press the FEED key to accept them and
terminate the download process. If they are incorrect, turn the unit off
without pressing the FEED key and begin the download process again at
Step 1.
Example:
Command Structure
<ESC>LD,a,b,c,d,e,f,g,h,i
a = Replacement character for STX in ASCII or hex format
b = Replacement character for ETX in ASCII or hex format
c = Replacement character for ESC in ASCII or hex format
d = Replacement character for ENQ in ASCII or hex format
e = Replacement character for CAN in ASCII or hex format
f = Replacement character for NULL in ASCII or hex format
g = Replacement character for OFFLINE in ASCII or hex format
h = Auto-Online. Printer powers up in the Online mode.
0 = Yes
1 = No
i = Zero Slash. Places a slash through the "0" character.
0 = Yes
1 = No
Example: <ESC>LD,{,},%,#,&,*,~,0,0
Placement: Immediately following the <ESC>A Start command and in an independent
data stream.
Default: Standard Protocol command codes
Command Function
Allows the user to define custom Protocol Command codes.
Printer Input
Allows the user to define custom Protocol Command codes.
{^A^LD,{,},%,#,&,*,~,0,0^Z}
(Next Page)