Filter
Top Products
SATO M-5900RV Operator and Technical Reference Manual
Page 2-41
Section 2. Installation and Configuration
PN 9001081
Rev. C
Pitch
After the pitch has been set, it is sometimes desirable to make minor adjustments. This
can be done using the PITCH potentiometer ont the front panel. This potentiometer
is set at the factory so that it has a range of +/- 3.75 mm. The midpoint setting should
have no effect on the pitch. Turning the potentiometer all the way clockwise should
move the print position 3.75 mm up towards the top edge of the label. Turning it all
the way counterclockwise should move the print position down 3.75 mm.
STEP PROCEDURE
1. While depressing the FEED key on the front panel turn the printer on.
2. Refer to Page 2-36, "Printing Test Labels" and print a label, large or
small.
3. Adjust the PITCH potentiometer on the front panel until the first print
position is at the desired location on the label. If the potentiometer
does not have enough range, then you will must change the pitch
setting using the front panel display.
4. Press the FEED key to stop the printer.
Adjusting the PITCH potentiometer will affect the stop position of the
label and the cut/dispense/tear-off postition.
Potentiometer Adjustments
ABCDEFGH
ABCDEFGH
ABCDEFGH
Label Feed
Direction
Moved with
Minus (-) Pitch
Potentiometer
Original Position on
Label
Moved with
Positive (+) Pitch
Potentiometer