Filter
Top Products
SATO M-5900RV Operator and Technical Reference Manual
Page 4-107
Section 4. Programming Reference
PN 9001081
Rev. C
Two-Dimensional Bar Codes
PDF417
Special Notes
1. When the code words per line and the number of rows per symbol ("dd" and "ee")
are set to all zeroes, the printer will calculate the optimum configuration.
2. If the product of the values entered for "dd" and "ee" are not equal to or less than the
value of "fff" (i.e., "ffff" is greater than "dd" x "ee"), an error will occur and the symbol
will not be printed. It is recommended that these values each be set to "000" and the
printer be allowed to automatically calculate the optimum values.
3. The values for "dd" and "ee" need to be made larger if the security level is increased.
4. The maximum data length is 2700 characters, but may be less depending upon:
• the minimum module dimension ("aa")
• the security level specified by "c"
• the number of data characters
5. The Reference Point of the PDF417 symbol is the upper-left corner.
6. The <ESC>F Sequential numbering command cannot be used with this command.
7. The <ESC>E Line Feed command cannot be used with this command.
8. The Macro and Truncated PDG417 symbols are not supported.
9. The values 00
H
thru 1F
H
can be specified as print data.
10. This command can be stored in a format.
11. The <ESC>R Rotate command can be used.
12. The print height of the symbol will vary depending upon the data specified, numeric
only, alpha only, or alphanumeric.
Printer Output