Filter
Top Products
SATO M-5900RV Operator and Technical Reference Manual
Page 6-1
PN 9001081
Rev. C
This section has been devised to help you if you are unable to produce output
on the M-5900RV. Use this section to make sure the basics have been checked
before deciding you are unable to proceed any further. This section covers the
following:
Initial Checklist
Centronics Parallel Interface
RS232C Serial Interface
Error Signals
Diagnosing and Correcting Specific Problems
6.2 Initial Checklist
1. Is the printer powered up and On-Line
2. Is the Print Head in the down and latched position?
3. Verify that you've selected the appropriate label sensor in the printer
configuration. See-Thru is used with label backing; Reflective is used
with I-Marks on labels or tags; Non is used for continuous form
labels. (See the Dip Switch Settings in Section 2.)
4. Make sure you've configured the proper RS232C interface options
consistent with the host configuration.
$
Section
Troubleshooting
6.1 Introduction