Filter
Top Products
SATO M-5900RV Operator and Technical Reference Manual
Page 2-23
Section 2. Installation and Configuration
PN 9001081
Rev. C
Printer Adjustments
To change the setting perform the following steps:
STEP PROCEDURE
1. Use the LINE key to step the underlined cursor to either the positive
(+) or the negative (-) selection. A positive selection increases the
pitch offset direction while a negative selection decreases the pitch
offset direction.
2. Once the desired setting is underlined, press the FEED key to accept
the (+/-) setting and advance to the first numerical position. Press the
LINE key to set a value in the first position (0-4 only). Each time the
line key is pressed, it will increment one step. Press the FEED key to
advance to the second position to set a value. Press the line key
repeatedly to advance to the desired value (0-9). Once the setting is
correct, press the FEED key to accept the setting and advance to the
Cancel Print job display.
3. You may wish to check your settings by printing a test label after you
have completed the adjustments to ensure that they are correct. See
page 2-36 for instructions on how to print a test label.
Pitch Offset and Direction