Filter
Top Products
Cuda 12000 IP Access Switch CLI-based Administration Guide
Packet Over SONET (POS) Interface Administration 119
Displaying POS Interface Information
You can display information for each POS interface. To do so, perform the
following task within root mode:
The following example uses the show topology command to obtain a list
of modules installed on the system, then uses the show interface
command to display information for the select POS interface.
cli:192.168.208.3:root# show topology
row count: 11
Chassis/Slot/ Class Interface Type Status
Interface
---------------- ---------- -------------------- --------------
1 / 1 / 1 Egress docsCableMaclayer Active
1 / 3 / 1 Egress Ethernet (Gigabit) Not In Service
1 / 8 / 1 Egress POS (OC3c) Not In Service
cli:192.168.208.3:root# show interface pos 1/8/1
---------------------------------------------------------
Interface Type sonet
POS 1/8/1 (line protocol) closed
---------------------------------------------------------
Hardware is Packet Over Sonet
Internet Address 155.144.1.1
Rx Giants 0
Bad FCS's 0
Bad Addresses 0
Bad Controls 0
Local MRU 1500 (bytes)
Remote MRU 1500 (bytes)
FCS Size 32 (bits)
Transmission Errors (Tx) 0
Rx Abort 0
Rx Runts 0
Interface Type ppp
Interface Speed 155520 (Kbits)
Interface In Octets 0
Interface In Unicast Pkts 0
Interface In Multicast Pkt 0
Task Command
Display POS interface statistics
and settings.
show interface pos <c/s/i>