Filter
Top Products
Cuda 12000 IP Access Switch CLI-based Administration Guide
Configuring Point-to-Point Protocol (PPP) 143
Perform the following tasks within interface pos <c/s/i> mode to configure
PPP PAP server-side security parameters:
Task Command
1. Enable PAP authentication ■ To enable the use of PAP only:
ppp authentication pap
The interface will use PAP
authentication only; no negotiation.
■ To enable PAP then CHAP:
ppp authentication pap chap
The interface will negotiate the
authentication protocol to use. It will try
to agree on PAP authentication first,
then CHAP second.
■ To enable CHAP then PAP:
ppp authentication chap pap
The interface will negotiate the
authentication protocol to use. It will try
to agree on CHAP authentication first,
then PAP second.
2. Configure the username and
password that a requesting
client must provide for
authentication to allow the
connection.
ppp username <name> password
<password>