Filter
Top Products
Cuda 12000 IP Access Switch CLI-based Administration Guide
Configuring OSPF 301
OSPF Configuration Task Overview
Configuration of the Cuda 12000 within an OSPF network includes:
■ Configuring OSPF Global Parameters
■ Adding OSPF Areas
■ Removing OSPF Areas
■ Configuring OSPF on IP Interfaces
■ Removing OSPF from IP Interfaces
■ Configuring OSPF Virtual Interfaces
■ Removing OSPF Virtual Interfaces
■ Configuring OSPF Neighbor Traps
Configuring OSPF Global Parameters
OSPF Global Parameters provide information about this router to other OSPF
routers in the autonomous system. These global parameters include:
Table 14-3 OSPF Global Parameters
Parameter Description
OSPF Router ID The OSPF router ID uniquely identifies this
router to other routers in the autonomous
system. It is recommended that you use
one of the system’s IP addresses or define
an IP address that is unique to the network.
Autonomous System Boundary
Router (ASBR)
Configures this router as an ASBR.
OSPF Administration State Enables or disables the OSPF protocol on a
system-wide basis. If enabled, this router
participates in the OSPF network; otherwise
the system does not participate.
OSPF Neighbor State and OSPF
Virtual Neighbor State Traps
Enables or disables sending of OSPF
neighbor state and OSPF virtual neighbor
state traps. Refer to “Configuring OSPF
Neighbor Traps” on page 318 for more
information.