ADC Telecommunications, Inc.
406 C
HAPTER 18: CONFIGURING CABLE MODEM TERMINATION SYSTEMS
Enable Zero Power Adjustment
If enabled, the power adjustment field in the range response message is
unconditionally set to 0. Useful for debugging. By default, Enable Zero
Power Adjustment is disabled.
You enable or disable zero power adjustment on an upstream channel by
performing the following tasks.
.
Enable Zero Timing Adjustment
If enabled, the timing adjustment item in range response message is
unconditionally set to 0. Useful for debugging. By default, Enable Zero
Timing Adjustment is disabled.
You enable or disable zero timing adjustment on an upstream channel by
performing the following tasks.
.
Task Command
1. Enable interface cable mode. interface cable <c/s/i>
2. Enable or disable zero power
adjustment.
upstream <port number> ranging
zero-power-adjust {enable | disable}
Task Command
1. Enable interface cable mode. interface cable <c/s/i>
2. Enable or disable zero timing
adjustment.
upstream <port number> ranging
zero-timing-adjust {enable | disable}