Filter
Top Products
Cuda 12000 IP Access Switch CLI-based Administration Guide
Sample SNMP Configurations 201
Sample Notification Configuration
The following sample commands configure the Cuda 12000 to send
SNMPv1 traps to a host (201.1.1.20):
cli:192.168.208.3:root# snmp-server view allaccess 1.3.6.1 included
cli:192.168.208.3:root# snmp-server group trapcommunity v1 notify allaccess
cli:192.168.208.3:root# snmp-server group trapcommunity v2 notify allaccess
cli:192.168.208.3:root# snmp-server community trapcommunity trapcommunity
cli:192.168.208.3:root# snmp-server host 201.1.1.20 trapcommunity traps version 1
In this example, the SNMP agent on the Cuda 12000 sends SNMPv1 traps
(on the default UDP port of 162) to a host with an IP address of 201.1.1.20.
Because the administrator does not specify any notification types, all types
are sent.
The administrator creates two group entries for community-based
SNMPv1/v2c access. Each group entry is assigned a notify view of “allaccess”
that allows notifications access to the entire MIB (this community has no
read or write access). The community inserted into outgoing traps will be
“trapcommunity.”
To send SNMPv2 traps instead of SNMPv1 traps, the administrator would
issue the same commands except for a slightly different version of the
snmp-server host command:
cli:192.168.208.3:root# snmp-server host 201.1.1.20 trapcommunity traps version 2c
To send inform messages instead of traps, another form of the snmp-server
host command would be used:
cli:192.168.208.3:root# snmp-server host 201.1.1.20 trapcommunity informs version 2c
This command sends inform messages with the default timeout and retries
values set. To change the defaults to 20 (for timeout) and 5 (for retries), the
administrator would issue the following command:
cli:192.168.208.3:root# snmp-server host 201.1.1.20 trapcommunity informs timeout 20
retries 5 version 2c