ADC Telecommunications, Inc.
190 C
HAPTER 9: SIMPLE NETWORK MANAGEMENT PROTOCOL (SNMP)
■ bcm-sw-mismatch The secondary will not come up
because its software revision does not
match the software revision of the
primary.
■ trace-log For ADC internal use only.
■ cold-start Generated when module boots from
power up.
■ warm-start Generated when module boots from
reset.
■ icl-state-change A change in the ICL link.
Module- events: Module events refer to hardware
faults that affect any application
module.
■ cable-modem-auth-failure Cable modem failed authorization and
did not register.
■ cable-modem-down Cable modem is not operational.
■ cable-modem-up Cable modem is operational.
■ card-down Application module failure.
■ card-up Application module is operational.
■ dhcp-relay-not-configured DHCP configuration error.
■ local-sonet-alarm A transmission problem is detected
from the transmitter.
■ remote-sonet-alarm A transmission problem is detected
from the receiver.
■ Interface-related events: Interface-related events refer to faults
that affect the link state of the
interface.
■ link-up Link to IP network is operational.
■ link-down Link to IP network is not operational.
■ chassis-fault Auxiliary device-related event that
refers to faults associated to the fan
tray, power source and clock sources.
NOTE: Reference “Timing and Alarm
Module Fault Reporting” on page 155,
for a list of the chassis-related
notification types.
Parameter Description