Cuda 12000 IP Access Switch CLI-based Administration Guide
Configuring RIP 291
Descriptions of the RIP parameters that you configure are listed below.
Table 14-2 RIP Parameters
Parameter Description
IP Address IP address of the current interface.
Send Version Version of RIP packets this router will send
on this interface ((RIP v1), (RIP v2), (RIPv1 or
RIPv2) or none).
Receive Version Versions of RIP packets the router will
accept on this interface ((RIP v1), (RIP v2),
(RIPv1 or RIPv2) or none).
Cost Cost or metric of the current interface. This
cost is added to all routes that are learned
from this interface, except the default route
if a default cost is specified. Routers use cost
values to select the best route to a
destination. When multiple routes to a
destination exist, routers select the route
with the lowest cost.
Authentication ON Whether authentication is performed on RIP
packets received on the interface.
Authentication Type Method of authenticating RIP packets on
this interface. If authentication is performed
on the interface, it specifies the type of
authentication (md5, simple password, or
no authentication) that RIP uses as a security
measure to ensure that this interface is
exchanging information with proper
neighbors.
Send Default Only Whether the Cuda 12000 advertises only its
default route on the interface.
Send Default Also Whether the Cuda 12000 advertises its
default route on the interface (in addition to
other routes). The default route is the one
that the Cuda 12000 selects when it does
not have a specific route to a destination
network, subnetwork, or host.