ADC 3 Switch User Manual


 
ADC Telecommunications, Inc.
18 C
HAPTER : ABOUT THIS GUIDE
Part III: IP Routing
Chapter 11: Creating Route Filters — Provides information and
procedures for creating RIP and OSPF policy-based route filters.
Chapter 12: Configuring DHCP Relay — Provides information and
procedures on how to configure DHCP relay on a cable interface.
Chapter 13: Configuring DHCP Authority — Provides information and
procedures on how to configure DHCP authority on a cable interface.
Chapter 14: Configuring IP — Provides information and procedures on
how to configure IP routing on your system. Includes information on
Open Shortest Path First (OSPF) and Routing Information Protocol (RIP)
configuration.
Chapter 15: IP Packet Filtering — Provides information and procedures
for creating packet filters for cable interfaces.
Chapter 16: Network-Layer Bridging — Provides information and
procedures for creating network-layer bridge groups. These bridge
groups allow you to associate the same IP address with multiple system
interfaces. A key value of this feature is the ability to span a single subnet
across multiple system modules.
Chapter 17: Managing IP Multicast — Provides information and
procedures for configuring the Cuda 12000 to route multicast traffic,
which delivers a single stream of information to multiple destinations at
one time. Includes information on IGMP and multicast routes.
Part IV: Cable Modem Termination Systems
Chapter 18: Configuring Cable Modem Termination Systems
Provides information and procedures for configuring and managing
CMTS RF parameters. Provides instruction on the configuration of
downstream and upstream channels, admission control, and advanced
CMTS parameters.
Chapter 19: Managing Cable Modems — Provides information for
managing and monitoring cable modems on the network.
Chapter 20: Subscriber Management — Describes how to configure
subscriber traffic filtering and Customer Premise Equipment (CPE) device
management on the Cuda 12000.
Chapter 21: MIB Browsing — Provides information on how to browse
cable modem and MTA MIBs and the MIB objects that are returned.