Filter
Top Products
ADC Telecommunications, Inc.
430 C
HAPTER 18: CONFIGURING CABLE MODEM TERMINATION SYSTEMS
Flap-list power-adj-threshold
The Flap-list power-adj-threshold parameter records a flap list event. When
the power adjustment of a modem exceeds the threshold, the modem is
placed in the flap list. Setting this parameter to zero results in modems never
being inserted in the flap list table due to power adjustments. By default, the
flap-list power-adj-threshold parameter is set at 3. Acceptable values are 1 to
10 dBmv.
You configure the power adjustment threshold by performing the following
tasks:
.
Show flap-list control
The Show flap-list control parameter displays all flap list control
configuration, which you can use to verify the configuration.
Display the flap-list control information by performing the following tasks:
.
For more information about flap lists, see “Managing Flap Lists” on
page 466.
Task Command
1. Enter cable interface mode. interface cable <c/s/i>
2. Set flap list power adjustment
threshold.
flap-list power-adj-threshold
<value>
Task Command
1. Enter cable interface mode. interface cable <c/s/i>
2. Display flap list control configuration. show flap-list control