Filter
Top Products
ADC Telecommunications, Inc.
308 C
HAPTER 14: CONFIGURING IP
Configuring OSPF Parameters for an IP Interface
After you have entered IP address configuration mode and assigned an
area ID to the IP interface, you can then configure OSPF parameters on the
interface.
To do so, perform the following tasks within IP address configuration mode:
Task Command
1. Configure the cost for this OSPF
interface.
ip ospf cost <number>
2. Configure the dead-interval for this
OSPF interface, in seconds. When
OSPF is initially enabled on the
interface, the dead interval defaults to
40 seconds.
The Cuda 12000 and all of its OSPF
neighbors on the IP interface you are
configuring must have matching dead
interval values. Otherwise, the
neighbors cannot form adjacencies.
ip ospf dead-interval <seconds>
3. Configure the Hello interval for the
current OSPF interface, in seconds.
When OSPF is initially enabled on the
interface, the hello interval defaults to
10 seconds.
The Cuda 12000 and all of its OSPF
neighbors on the IP interface you are
configuring must have matching hello
interval values. Otherwise, the
neighbors cannot form adjacencies.
ip ospf hello-interval <seconds>