Filter
Top Products
ADC Telecommunications, Inc.
304 C
HAPTER 14: CONFIGURING IP
For more information on these commands, refer to the Cuda 12000 IP
Access Switch CLI Reference Guide.
The no forms of the ospf command enable you to perform the following
tasks from within router ospf mode:
4. Configure the default cost only if
this is an ABR connected to a stub
area. The default cost is the metric
assigned to the summary default
route injected into the area by this
router.
ospf area <area-id> default-cost
<cost value>
5. If you want to summarize routes
injected into the area, use this
command to define the area
range.
ospf area <area-id> range
<ip address> <mask>
[advertise-matching]
6. Configure authentication for this
area.
ospf area <area-id> authentication
{md5 | password}
Specify “md5” to configure MD5
password authentication; “password”
to configure simple password
authentication.
7. Enable or disable this OSPF area. ospf area <area-id> {enable | disable}
8. Display the OSPF area to verify
configuration.
show ospf area <area-id>
Task Command
1. Remove an OSPF area. Refer to “Removing OSPF Areas” on
page 305.
2. Remove a summary range. no ospf area <area-id> range
<ip address> <mask>
[advertise-matching]
3. Disable authentication for the
area.
no ospf area <area-id>
authentication
Task Command