Cuda 12000 IP Access Switch CLI-based Administration Guide
Creating Route Maps 227
Using the Match Command
Use the match command within route-map configuration mode to define
the match criteria for the route map. Refer to the following sections for more
information on using this command:
■ “Creating OSPF Import Route Maps” on page 229
■ “Creating OSPF Export Route Maps” on page 231
■ “Creating RIP Import Route Maps” on page 234
■ “Creating RIP Export Route Maps” on page 236
The following example sets match attributes for route-map 80, then verifies
the new route-map configuration using the show route-map command:
cli:172.16.19.10:router:ospf:export:route-map(80)# match ip-address 172.16.19.0
255.255.255.0
cli:172.16.19.10:router:ospf:export:route-map(80)# match route-type rip
cli:172.16.19.10:router:ospf:export:route-map(80)# show route-map 80
ID 80
Description
Route Address 172.16.19.0
Route Mask 255.255.255.0
Type RIP
Specific1 0.0.0.0
Specific2 0.0.0.0
Tag 0
Key Bits 5
Metric 0
Flags 1
Action Tag 0
cli:172.16.19.10:router:ospf:export:route-map(80)#