Filter
Top Products
Cuda 12000 IP Access Switch CLI-based Administration Guide
Modifying CPE Control Parameters Per Cable Modem 515
Modifying CPE Control Parameters Per Cable Modem
The Cuda 12000 allows the network administrator to modify Subscriber
Management CPE control per cable modem. Modifications on a per-cable-
modem basis are not persisted on the Route Server, and are sent in the form
of SNMP sets directly to the cable modem. The next time the cable modem
re-initializes, the changes are wiped out and the cable modem uses the
default CPE control settings.
Per cable modem, you can:
■ Specify whether or not you want to apply Subscriber Management to CPE
devices associated with the cable modem.
■ Change the maximum number of IP addresses available to the CPE
devices associated with the cable modem.
■ Specify you want IP addresses of CPE devices associated with the cable
modem to be learned by the CMTS.
The following table lists the parameters that you set to modify Subscriber
Management CPE control:
Table 20-5 Parameters for Modifying Subscriber Management CPE Control
Parameter Description
IP Address The IP address of the cable modem that
provides network access to the CPE devices you
want to control.
MAC Address The MAC address of the cable modem that
provides network access to the CPE devices you
want to control.
SID A service identifier of the cable modem that
provides network access to the CPE devices you
want to control.