Filter
Top Products
edge switch 2/16 service manual 3–33
Repair Information
Figure 3–18: Data Collection Dialog Box
7. Click Close to close the dialog box.
8. Remove the Zip disk with the newly-collected maintenance data from the HAFM
server Zip drive. Return the Zip disk to Hewlett Packard for failure analysis.
9. To ensure the QuikSync backup application operates normally, replace the original
backup disk in the HAFM server Zip drive.
Clean Fiber-Optic Components
Perform this procedure as directed in this publication and when connecting or
disconnecting fiber-optic cables from switch SFP optical transceivers (if necessary).
To clean fiber-optic components:
1. Obtain the appropriate tools (portable can of oil-free compressed air and alcohol
pads) from the fiber-optic cleaning kit.
2. Disconnect the fiber-optic cable from the SFP. Use compressed air to blow any
contaminants from the connector as shown in part A of Figure 3–19.
— Keep the air nozzle approximately 50 millimeters (two inches) from the end
of the connector and hold the can upright.
— Blow compressed air on the surfaces and end of the connector continuously
for approximately five seconds.