Filter
Top Products
edge switch 2/16 service manual 2–33
Diagnostics
2
The following table lists event codes, brief explanations of the codes, and the
associated steps that describe fault isolation procedures.
3
POST/IPL diagnostics detected a CTP card failure as indicated by an event code 400
with supplementary bytes of event data.
• Byte 0 is a FRU code (02) that indicates a failed CTP card.
• Byte 1 is the slot number (00) for the CTP card.
Because the CTP card is not a FRU, replace the switch.
4
POST/IPL diagnostics detected a firmware failure (as indicated by event code 411)
and performed an online dump. All Fibre Channel ports reset after the failure and
attached devices momentarily logout, login, and resume operation.
Perform the data collection procedure and return the Zip disk to Hewlett Packard
support personnel.
MAP 0300: Console Application Problem
Determination
This map describes isolation of HAFM server application problems, including
problems associated with the Windows operating system and HAFM and switch
product manager.
1
Did the HAFM server lock up or crash without displaying a warning or error message?
YES NO
Event
Code Explanation Action
400 Power-up diagnostic failure. Go to step 3.
411 Firmware fault occurred. Go to step 4.