Filter
Top Products
48
Initial Tab Copy Setting
This is used to set the default image shift width (tab
width) for tab copying.
The default width can be set from 0" (0 mm) to 5/8"
(20 mm) in increments of 1/8" (1 mm).
Disabling Deletion of Job Programs
This is used to prohibit the deletion and changing of copy
settings stored in job programs.
Disabling of Bypass-Tray in
Duplex Copy
This is used to prohibit the use of the bypass tray when
making two-sided copies.
The bypass tray is often used to feed label sheets,
transparency film, and other special media for which
two-sided copying is prohibited. If a sheet of one of these
special media enters the reversing unit, a misfeed or
damage to the unit may result. If special media for which
two-sided copying is prohibited is often used, it is
recommended that you enable this setting.
Disabling of Auto Paper Selection
This setting is used to disable the Auto Paper Selection
function.
When this setting is enabled, automatic selection of
paper that is the same size as the original on the
document glass or in the automatic document feeder
does not take place.
Auto Selection Setting of Tray that
is Supplied the Paper
When this setting is enabled and paper is loaded in a
tray while the machine is on standby in copy mode, that
tray is automatically selected.
600dpi x 600dpi Scanning Mode for
Document Feeder
The resolution used when scanning originals on the
document glass can be set to 600 x 600 dpi (high quality
mode).
When this setting is disabled, originals are scanned at
600 x 300 dpi.
When high quality mode is used, fine print and thin lines
are reproduced with greater clarity, however, the
scanning speed is slower.
Quick Scan from Document Glass
The resolution used when scanning originals on the
document glass can be set to 600 x 300 dpi (speed
priority mode).
When this setting is disabled, originals are scanned at
600 x 600 dpi.
When high speed mode is selected, the first copy time is
quicker, however, the copy image is not as clear.
When this setting is enabled to give priority to job
speed, the following conditions must all be met in
order for scanning to take place at the set resolution.
• The copy ratio must be set to 100%.
• Do not select a special mode that will change the
ratio.
When this setting is disabled to give priority to job
speed, the following conditions must all be met in
order for scanning to take place at the set resolution.
• The copy ratio must be set to 100%.
• Do not select a special mode that will change the
ratio.