Filter
Top Products
88
The paper misfeeds. Is 5-1/2" x 8-1/2" (A5) size paper
loaded?
Load 5-1/2" x 8-1/2" (A5) size paper in tray 4 (the
second tray) or in the bypass tray.
For the paper trays in which A5 size paper can be
loaded, see "PAPER TRAY SETTINGS" (page 77).
* When loading 5-1/2" x 8-1/2" (A5) size paper, place
the paper in the horizontal (5-1/2" x 8-1/2"R (A5R))
orientation.
Has the correct paper size been set? If you are using a special size, be sure to specify the
paper size.
If the size of paper loaded in a tray was changed, be
sure to check the paper size setting.
☞ PAPER TRAY SETTINGS (page 77)
Did you add paper to the bypass tray? When adding paper, remove any paper remaining in the
bypass tray, combine it with the paper to be added, and
reload as a single stack. If paper is added without
removing the remaining paper, a misfeed may result.
☞ LOADING PAPER IN THE BYPASS TRAY (page
48)
Paper does not feed
from the paper tray.
Is the paper loaded correctly in the
paper tray?
Set the guides to the size of the paper. Make sure the
height of the paper does not exceed the indicator line.
☞ 2. LOADING PAPER (page 26)
In the Paper Tray Settings of the system
settings, are restrictions placed on the
trays that can be used in each mode
(copy, print, fax, Internet fax, and
document filing)?
Check the Paper Tray Settings and see if checkmarks
appear in the checkboxes of each mode (Feeding
Approved Job). Functions without a checkmark cannot
be used for printing using that tray.
☞ PAPER TRAY SETTINGS (page 77)
The image on paper is
skewed.
Is too much paper loaded in the bypass
tray?
Do not load more than the maximum number of sheets.
The maximum number of sheets varies depending on
the paper type setting. For more information, see the
specifications in the Safety Guide.
Are the bypass tray guides adjusted to
the width of the paper?
Adjust the bypass tray guides to the width of the paper.
☞ LOADING PAPER IN THE BYPASS TRAY (page
48)
Are the original guides adjusted to the
width of the paper?
Adjust the original guides to the width of the paper.
☞ PLACING ORIGINALS IN THE AUTOMATIC
DOCUMENT FEEDER (page 53)
The automatic
document feeder does
not operate.
Have functions been disabled by the
administrator?
Some functions may have been disabled in the system
settings (administrator). Check with your administrator.
Problem Point to check Solution