Symbol Technologies SPT 1700 Scanner User Manual


 
1-14
SPT 1700 Series Product Reference Guide
Charging the Battery
Before using your SPT 1700 for the first time, charge the lithium-ion battery. The terminals
battery can be charged using the Cradle, the Synchronization/Charging Cable, or the
Universal Battery Charger (UBC). For instructions on using the UBC to charge your
batteries, refer to the Quick Reference Guide which came with your UBC. Follow these
same procedures to recharge the battery when the terminals battery level is low.
Using the Cradle to Charge the Battery
To charge the terminals battery using the CRD 1700 cradle:
1. Make sure the battery is installed in the terminal. Refer to
Installing the Battery
on
page 1-13 for instructions.
2. Make sure the cradle is plugged into a wall outlet.
3. Insert the SPT 1700 terminal in the cradle as shown:
On the CRD1700-1000S, the battery charging LED turns red to indicate that the battery is
charging, then turns green after approximately two hours to indicate that the terminals
battery is fully charged.
Spare Battery Charging
The CRD1700-1000S single-slot cradle has a spare battery charging slot which charges
the terminals spare battery. Insert the battery in the spare battery charging slot in the back
of the cradle. The spare battery charging LED turns red to indicate the spare battery is
Battery
Charging
LED