2-10
SPT 1700 Series Product Reference Guide
3. Tap Other if you need to enter a Service Provider Interface number representing a
different carrier. The following screen displays:
4. Enter the SPI number and tap
Done
.
5. The Network Provider screen reappears. Tap
Next
to
continue.
Note:
The Setup Wizard will not proceed until a CDPD carrier selection
has been made.
6. The Configure Palm Device screen displays:
7. Tap the
Configure Preferences
button to configure the terminal with the network
library settings that Symbol recommends. A “Palm Configuration Complete”
message will display below the
Configure Preferences
button when the process is
finished.
Note:
If you are confident that the Network Preferences are correct, you
may bypass this step. However, it strongly suggested that you verify
preference configuration.