Filter
Top Products
136 Operation
Chapter 5 - Command Line Interface
5.3 Command Groups
The system commands can be broken down into the functional groups shown
below.
Table 5-3: Command Group
Command Group Description Page
General Basic commands for entering configuration mode, restarting the system, or
quitting the CLI
138
System Management Controls user name, password, web browser management options, and a
variety of other system information
143
System Logging Configures system logging parameters 161
System Clock Configures SNTP and system clock settings 166
DHCP Relay Configures the AP to send DHCP requests from clients to specified servers 170
SNMP Configures community access strings and trap managers 172
Flash/File Manages code image or AP configuration files 185
RADIUS Configures the RADIUS client used with 802.1X authentication 188
802.1X Authentication Configures 802.1X authentication 195
MAC Address
Authentication
Configures MAC address authentication 198
Filtering Filters communications between wireless clients, controls access to the
management interface from wireless clients, and filters traffic using specific
Ethernet protocol types
202
WDS Bridge Not applicable for the current release 207
Spanning Tree Not applicable for the current release 208
Ethernet Interface Configures connection parameters for the Ethernet interface 209
Wireless Interface Configures radio interface settings 214
Wireless Security Configures radio interface security and encryption settings 231
Rogue AP Detection Configures settings for the detection of rogue APs in the network 231
Link Integrity Configures a link check to a host device on the wired network 243
IAPP Enables roaming between multi-vendor APs 246
VLANs Configures VLAN membership 247
WMM Configures WMM quality of service parameters 250