Filter
Top Products
166 Operation
Chapter 5 - Command Line Interface
5.7 System Clock Commands
These commands are used to configure SNTP and system clock settings on the AP.
5.7.1 sntp-server ip
This command sets the IP address of the servers to which SNTP time requests are
issued. Use the this command with no arguments to clear all time servers from
the current list.
Syntax
sntp-server ip <1 | 2> <ip>
• 1 - First time server.
• 2 - Second time server.
• ip - IP address of an time server (NTP or SNTP).
Table 5-8: System Clock Commands
Command Function Mode Page
sntp-server ip Specifies one or more time servers GC 166
sntp-server enable Accepts time from the specified time servers GC 167
sntp-server date-time Manually sets the system date and time GC 167
sntp-server
daylight-saving
Sets the start and end dates for daylight savings time GC 168
sntp-server timezone Sets the time zone for the AP’s internal clock GC 168
show sntp Shows current SNTP configuration settings Exec 169