Filter
Top Products
Advanced Configuration
BreezeMAX Wi² and BreezeACCESS Wi² System Manual 69
4.4.10.2 Setting the Timeout Interval
You can set the timeout interval for web access to the unit, after which the user
will have to re-enter the username and password.
Session Timeout for WEB: Sets the time limit for an idle web interface session.
(Range: 0-1800 seconds; Default: 300 seconds; 0 is disabled)
4.4.10.2.1 CLI Command for the Web Session Timeout
Use the ip http session-timeout command from the CLI configuration mode.
4.4.10.3 Upgrading Firmware
You can upgrade new AP software from a local file on the management
workstation, or from an FTP or TFTP server. New software may be provided
periodically from your distributor.
After upgrading new software, you must reboot the AP to implement the new code.
Until a reboot occurs, the AP will continue to run the software it was using before
the upgrade started. Also note that new software that is incompatible with the
current configuration automatically restores the AP to the factory default settings
when first activated after a reboot.
Figure 4-11: Session Timeout for WEB
Enterprise AP(config)#ip http session-timeout 0 149
Enterprise AP(config)#