Filter
Top Products
68 Operation
Chapter 4 - System Configuration
4.4.9.0.1 CLI Commands for AP Management features.
4.4.10 Administration
4.4.10.1 Changing the Password
Management access to the web and CLI interface on the AP is controlled through a
single user name and password. You can also gain additional access security by
using control filters (see “Filter Control” on page 61).
To protect access to the management interface, you need to change the default
user name and password as soon as possible. If the user name and password are
not changed, anyone having access to the AP can compromise AP and network
security. Once a new administrator has been configured, you can delete the
default admin user name from the system.
Username – The name of the user. The default name is admin. (Length: 3-16
characters, case sensitive)
New Password – The password for management access. (Length: 3-16 characters,
case sensitive)
Confirm New Password – Enter the password again for verification.
4.4.10.1.1 CLI Commands for Changing User Name and Password
Use the username and password commands from the CLI configuration mode.
Enterprise AP(config)#apmgmtip multiple 192.168.1.6 255.255.255.0 151
Enterprise AP(config)#apmgmtui SNMP enable 152
Figure 4-10: Administration
Enterprise AP(config)#username bob 146
Enterprise AP(config)#password admin 147
Enterprise AP#