Filter
Top Products
178 Operation
Chapter 5 - Command Line Interface
Example
5.9.9 snmp-server targets
This command configures SNMP v3 notification targets. Use the no form to delete
an SNMP v3 target.
Syntax
snmp-server targets <target-id> <ip-addr> <sec-name>
[version {3}] [udp-port {port-number}] [notification-type
{TRAP}]
no snmp-server targets <target-id>
• target-id - A user-defined name that identifies a receiver of SNMP notifications. (Maximum length:
32 characters)
• ip-addr - Specifies the IP address of the management station to receive notifications.
• sec-name - The defined SNMP v3 user name that is to receive notifications.
• version - The SNMP version of notifications. Currently only version 3 is supported in this
command.
• udp-port - The UDP port that is used on the receiving management station for notifications.
• notification-type - The type of notification that is sent. Currently only TRAP is supported.
Default Setting
None
Command Mode
Global Configuration
Command Usage
• The AP supports up to 10 SNMP v3 target IDs.
• The SNMP v3 user name that is specified in the target must first be configured using the
snmp-server user command.
Example
5.9.10 snmp-server filter
This command configures SNMP v3 notification filters. Use the no form to delete
an SNMP v3 filter or remove a subtree from a filter.
Enterprise AP(config)#snmp-server user
User Name<1-32> :chris
Group Name<1-32> :RWPriv
Authtype(md5,<cr>none):md5
Passphrase<8-32>:a good secret
Privacy(des,<cr>none) :des
Passphrase<8-32>:a very good secret
Enterprise AP(config)#
Enterprise AP(config)#snmp-server targets mytraps 192.168.1.33 chris
Enterprise AP(config)#