Filter
Top Products
Installation
BreezeMAX Wi² and BreezeACCESS Wi²
System Manual 31
2.3.6 Connecting the Antenna(s)
1 Connect the external antenna directly to the N-type connector on the top panel
of the Wi² unit.
2 Set the antenna options for corresponding antenna through the user interface
(Section 5.18.10).
2.3.7 Connecting the Grounding Cables
1 Connect a grounding cable to the grounding stud on theWi² unit and tighten
the grounding screw firmly.
2 Connect a grounding cable to the grounding stud on the SU-ODU and tighten
the grounding screw firmly.
3 Connect the other ends of the grounding cables to a good ground (earth)
connection.
2.3.8 Connecting to Power Source
1 Connect the power cable (see Section 2.3.4) to the power socket on the unit
and to the mains supply.
To connect an external antenna:
NOTE
When connecting only one antenna, connect it to the right antenna connector. (When looking at the
unit from the side of the SU-ODU with the antenna connectors facing upwards, this is the
connector on the right.)
CAUTION
If using antennas other than the Omni 8, make sure you do not exceed local radio regulations.
To connect the grounding cables:
CAUTION
Be sure that grounding is available and that it meets local and national electrical codes. For
additional lightning protection, use lightning rods, lightning arrestors, or surge suppressors.