Filter
Top Products
20 Installation
Chapter 2 - Hardware Installation
1 Determine the tilt direction of the SU-ODU.
2 Using the 1/4” x 1/2” hex head screws and the flat washers and spring
washers supplied, attach the SU-ODU to the mounting plate as shown in
Figure 2-6 in the direction marked.
3 Tighten the screws. Apply torque of 57 lb*in [6.4 N*m].
Figure 2-5: Attaching BreezeMAX PRO-S ODU or BreezeACCESSSU-ODU with HW Revision E to
Mounting Plate
NOTE
For information about polarization refer to the relevant manual.
To attach a BreezeACCESS SU-ODU with HW Revision D or lower (rectangular) to
the mounting plate: