Filter
Top Products
System Clock Commands
BreezeMAX Wi² and BreezeACCESS Wi² System Manual 167
Default Setting
137.92.140.80
192.43.244.18
Command Mode
Global Configuration
Command Usage
When SNTP client mode is enabled using the sntp-server enable command, the sntp-server ip
command specifies the time servers from which the AP polls for time updates. The AP will poll the
time servers in the order specified until a response is received.
Example
Related Commands
sntp-server enable (page 167)
show sntp (page 169)
5.7.2 sntp-server enable
This command enables SNTP client requests for time synchronization with NTP or
SNTP time servers specified by the sntp-server ip command. Use the no form to
disable SNTP client requests.
Syntax
sntp-server enable
no sntp-server enable
Default Setting
Enabled
Command Mode
Global Configuration
Command Usage
The time acquired from time servers is used to record accurate dates and times for log events.
Without SNTP, the AP only records the time starting from the factory default set at the last bootup
(i.e., 00:14:00, January 1, 1970).
Example
Related Commands
sntp-server ip
(page 166)
show sntp (page 169)
5.7.3 sntp-server date-time
This command sets the system clock.
Enterprise AP(config)#sntp-server ip 10.1.0.19
Enterprise AP#
Enterprise AP(config)#sntp-server enable
Enterprise AP(config)#