Filter
Top Products
Installation
BreezeMAX Wi² and BreezeACCESS Wi²
System Manual 21
2.3.2 Attaching the Mounting Plate to the
Wi²
Unit
1 Hold the mounting plate with SU-ODU attached so the tilt label faces the tilt
direction that you have decided upon (see Section 2.3.1).
2 Using the M6 x 12 hex head screws and the flat washers and spring washers
supplied, attach the mounting plate to the Wi² unit as shown in Figure 2-7.
Figure 2-6: Attaching BreezeACCESS SU-ODU with HW Revision D or lower to Mounting Plate
NOTE
Sometimes, physical circumstance require that the SU-ODU be located at a distance from the Wi²
unit and not attached to the mounting plate. For further information see the section on SU-ODU
mounting in the relevant manual.