Filter
Top Products
Advanced Configuration
BreezeMAX Wi² and BreezeACCESS Wi² System Manual 49
4.4.1.0.1 CLI Commands for System Identification
Enter the global configuration mode, and use the system name command to
specify a new system name. Return to the Exec mode, and use the show system
command to display the changes to the system identification settings.
4.4.2 TCP / IP Settings
Configuring the AP with an IP address expands your ability to manage the AP. A
number of features depend on IP addressing to operate.
Enterprise AP#config 139
Enter configuration commands, one per line.
Enterprise AP(config)#system name R&D
146
Enterprise AP(config)#end 139
Enterprise AP#show system 153
System Information
==============================================================
Serial Number : 0000000000
System Up time : 2 days, 4 hours, 33 minutes, 38 seconds
System Name : R&D
System Location :
System Contact : Contact
System Country Code
System Country Code
Radio G MAC Address : 00-12-CF-12-34-95
IP Address : 192.168.1.2
Subnet Mask : 255.255.255.0
Default Gateway : 192.168.1.254
VLAN State : DISABLED
Management VLAN ID(AP): 1
IAPP State : ENABLED
DHCP Client : DISABLED
HTTP Server : ENABLED
HTTP Server Port : 80
HTTP Session Timeout : 300 sec(s)
HTTPS Server : ENABLED
HTTPS Server Port : 443
Slot Status : 802.11g only
Boot Rom Version : v2.1.6
Software Version : v4.3.3.8b02
SSH Server : ENABLED
SSH Server Port : 22
Telnet Server : ENABLED
DHCP Relay : DISABLED
==============================================================
Enterprise AP#
NOTE
You can use the web browser interface to access IP addressing only if the AP already has an IP
address that is accessible through your network.