Filter
Top Products
Installation
BreezeMAX Wi² and BreezeACCESS Wi²
System Manual 23
2 Expose the RJ-45 connector under the sealing cap on the Ethernet cable and
connect to the SU-ODU RJ-45 connector (Figure 2-9).
3 Put the sealing cap back in its place. Make sure that the small protrusion on
the side of the cap fits inside the hole on the connector's protective body.
4 Connect the other end of the Ethernet cable to the SU port on the Wi² unit.
5 Verify that the O-ring supplied with the service box kit is in place, attach the
service box to the unit and tighten the top nut.
6 Use appropriate sealing material to protect the connection to the SU-ODU
against moisture and humidity. Use removable sealing material to enable
future access to the connector.
Figure 2-8: Sealing Cap
Figure 2-9: Connecting the SU-ODU connector and inserting the Sealing Cap
NOTE
Use high quality sealing material such as Scotch® 130C Linerless Rubber Splicing Tape from 3M to
ensure IP-67 compliant protection against dust and water.
groove