Filter
Top Products
174 Operation
Chapter 5 - Command Line Interface
Default Setting
None
Command Mode
Global Configuration
Example
Related Commands
snmp-server contact
(page 173)
5.9.4 snmp-server enable server
This command enables SNMP management access and also enables this device to
send SNMP traps (i.e., notifications). Use the no form to disable SNMP service and
trap messages.
Syntax
snmp-server enable server
no snmp-server enable server
Default Setting
Enabled
Command Mode
Global Configuration
Command Usage
• This command enables both authentication failure notifications and link-up-down notifications.
• The snmp-server host command specifies the host device that will receive SNMP notifications.
Example
Related Commands
snmp-server host
(page 174)
5.9.5 snmp-server host
This command specifies the recipient of an SNMP notification. Use the no form to
remove the specified host.
Syntax
snmp-server host <1 | 2 | 3 | 4> <host_ip_address | host_name> <community-string>
no snmp-server host
• 1 - First SNMP host.
• 2 - Second SNMP host.
• 3 - Third SNMP host.
• 4 - Fourth SNMP host.
Enterprise AP(config)#snmp-server location WC-19
Enterprise AP(config)#
Enterprise AP(config)#snmp-server enable server
Enterprise AP(config)#