Filter
Top Products
BreezeMAX Wi² and BreezeACCESS Wi² System Manual 255
Appendix A -Troubleshooting
If you cannot connect using Telnet, you may have exceeded the maximum
number of concurrent Telnet sessions permitted (i.e, four sessions). Try
connecting again at a later time.
3 If you cannot access the on-board configuration program via a serial port
connection:
Be sure you have set the terminal emulator program to VT100 compatible,
8 data bits, 1 stop bit, no parity and 9600 bps.
4 If you forgot or lost the password:
Set the AP to its default configuration by pressing the reset button on the
back panel for 5 seconds or more. Then use the default user name admin
and a null password to access the management interface.
5 If all other recovery measure fail, and the AP is still not functioning properly,
take one of the following steps:
Reset the AP’s hardware using the console interface, web interface, or
through a power reset.
Reset the AP to its default configuration by pressing the reset button on the
back panel for 5 seconds or more. Then use the default user name admin
and a null password to access the management interface.