Filter
Top Products
94 PresentationPRO-II • User’s Guide
5. System Setup
Setting up the Background
rëáåÖ=~=j~ííÉ=`çäçê=~ë=íÜÉ=_~ÅâÖêçìåÇ
This procedure enables you to set up the background as a matte color that can be used
behind a PIP or Key.
Use the following steps to set up a solid matte color as a background source:
1. (Optional) To ensure that the full background is visible, clear any PIP, Key or
LOGO from Program.
2. In the Layer Functions Section, press BG/DSK. The button blinks and the BG/
DSK Input Setup Menu
appears.
3. Scroll to the Mode line and select BG.
4. Scroll to the Type line and select MATTE.
5. Press {MATTE} to display the Background Matte Menu.
6. Adjust the Red, Green and Blue values as desired. At this point, the selected
color is the new background that you can use behind PIPs and Keys.
7. Press {BACK} to return to the BG/DSK Input Setup Menu.
8.
Press {SAVE} to save the background input configuration.
rëáåÖ=íÜÉ=asf=fåéìí=~ë=íÜÉ=_~ÅâÖêçìåÇ
This procedure enables you to set up the DVI source as the background layer. The DVI
source originates from an external computer or other external device.
It is recommended that you perform these steps as a setup procedure. However, once the
DVI input is set, during live production you can switch the background between a Matte
color, a still frame and a DVI source.
Please remember that the
BG/DSK input is shared between BG and DSK. If you elect to
use a live DVI input as the background, it cannot be used as the DSK simultaneously.
Use the following steps to set up a DVI input as a background:
1. (Optional) To ensure that the full background is visible, clear any PIP, Key, or
LOGO from Program.
2. Ensure that the PresentationPRO-II EDID is properly programmed. Refer to the
“
Programming EDID” section on page 93 for instructions.
3. In the Layer Functions Section, press BG/DSK. The button blinks and the BG/
DSK Input Setup Menu
appears.
4. Scroll to the Mode line and select BG.
5. Scroll to the Type line and select DVI.
6. If required, press {FORCE ACQUIRE} to force the system to perform the optimum
setup on the DVI input. If the operation is successful,
Format and Type should
correctly reflect the characteristics of the incoming signal.
7. If required, scroll to the Format line and manually set the resolution of the
incoming source. In Appendix A, refer to the “
Input and Output Resolutions“
section on page 129 for details on all available resolutions.
8. If you manually selected a format in the previous step, press {SELECT FORMAT}
to “accept” and activate the selection.