Filter
Top Products
PresentationPRO-II • User’s Guide 97
5. System Setup
Setting up the DSK
rëáåÖ=~=píáää=cê~ãÉ=~ë=íÜÉ=aph
This procedure enables you to capture a still frame image and assign it as the “type” for the
DSK. Please note:
• As a recommendation, capture still frames into “temporary” memory as a setup
procedure.
• Once still frames are captured, during live production you can switch the DSK
between the DVI input and a Still Frame.
Use the following steps to assign a captured still frame as the DSK “type.”
1. Ensure that BG/DSK input is properly set up as a DVI source. This input is the
source of the still frames which you will capture. Refer to the “
Using the DVI
Input as the Background” section on page 94 for setup details.
2. In Chapter 6, refer to the “Capturing Still Frames” section on page 117 for
instructions on capturing still frames. Up to three frames can be captured into
temporary memory:
FG_1, FG_2 and FG_3.
3. In the Layer Functions Section, press BG/DSK. The button blinks and the BG/
DSK Input Setup Menu
appears.
4. Scroll to the Mode line and select DSK.
5. Scroll to the Type line and select the desired still frame: FG_1, FG_2 or FG_3.
Important
It is highly recommended that you save still frames into
“permanent” flash memory as a setup procedure — as this is
a very time-consuming step that locks the front panel of
PresentationPRO-II.