Filter
Top Products
PresentationPRO-II • User’s Guide 113
6. Operations
Working with Layers
ildl=qê~åëáíáçåë
With PresentationPRO-II, you can perform the following types of LOGO transitions:
• Transitioning the LOGO to Program
• Clearing the LOGO from Program
qê~åëáíáçåáåÖ=íÜÉ=ildl=íç=mêçÖê~ã
Using the LOGO source, you can transition a captured still frame to Program at the highest
priority layer — covering all effects underneath.
Use the following steps to transition the LOGO to Program:
1. Ensure that you have preset the desired transition type and rate. Refer to the
"
Working with Transitions" section on page 115 for details.
2. Ensure that the desired still frames have been captured. Refer to the “Still Frame
Capture Overview“ section on page 117 for details.
3. In the Layer Functions Section, press LOGO. The button blinks and the LOGO
Input Setup Menu
appears.
4. Scroll to the Type line and select FG_1, FG_2, FG_3 or Black.
5. In the Layer Functions Section, press TRANS. The TRANS button lights during
the interval, and at the conclusion of the transition, the
Home Menu appears.
`äÉ~êáåÖ=íÜÉ=ildl=Ñêçã=mêçÖê~ã
Use the following steps to clear the LOGO from Program:
1. Ensure that you have preset the desired transition type and rate. Refer to the
"
Working with Transitions" section on page 115 for details.
2. In the Layer Functions Section, press TRANS. The TRANS button lights during
the interval, and at the conclusion of the transition, the
Home Menu appears.
This simple shortcut works because the
LOGO is the only layer visible on
Program, and thus the only element that can transition off.
LOGO
Tip
In addition to its use as a full screen downstream graphic, the
LOGO can also be used as a convenient “black preview”
function. When the
LOGO source is set to Black, you can
fade to black at any time, from any simple or complex setup,
without affecting the underlying "look."
Note
If desired, you can also clear the LOGO by pressing LOGO,
CLEAR, TRANS.