Filter
Top Products
12 PresentationPRO-II • User’s Guide
2. Hardware Orientation
PresentationPRO-II Rear Panel
mêÉëÉåí~íáçåmolJff=oÉ~ê=m~åÉä
The figure below illustrates the PresentationPRO-II rear panel:
Figure 2-1. PresentationPRO-II Rear Panel
Following are descriptions of each rear panel connector and section.
1) SDI Input
One BNC connector is provided for an SD-SDI/HD-SDI input (HD model) or an
SD-SDI input (SDI model). This input is directly associated with the SDI source
button on the front panel’s top row.
Users can set the input to accept the following:
~ SDI (SMPTE 259M-C, NTSC or PAL). SDI and HD models.
~ HD-SDI (SMPTE 292M, HDTV). HD model only.
In Chapter 5, refer to the “
Comprehensive Input Setup” section on page 90 for
input setup instructions.
2) Analog Inputs
Eight 15-pin D connectors are provided for Analog Inputs. These numbered
inputs feed the system’s internal 8 x 1 analog router, and correspond directly to
the eight analog source buttons on the front panel.
Please note:
~ In Appendix A, refer to the “Analog 15-pin D Connector” section on
page 126 for pinout details.
~ Refer to the “Analog Input Flexibility” section on page 14 for additional
information about each analog input connector.
6
7
31 2 4 5
1) SDI Input 4) Program Outputs 7) Serial Ports
2) Analog Inputs 5) Ethernet Port
3) Background/DSK Input 6) AC Connector