Filter
Top Products
Chapter 8 Setup and Other Utilities in the Desktop Manager 8-9
❍ Speed
You set the transmission speed used to receive faxes. The higher the
setting, the faster the fax is received. If you experience problems when
receiving faxes, try a lower speed setting.
❍ Error Correction (ECM)
You select this option to reduce system and line errors when receiving
a fax. With this option selected, the system checks each incoming fax
for lost data. If data has been lost from a portion of a page, the system
receives that portion again after confirming that all data within that
portion can be received successfully.
❍ Ink/Toner Saver
You select this option to print documents in the Desktop Manager
using a reduced amount of toner. When using Ink/Toner Saver mode,
the print document may appear less bright or contrasted.
❍ Fax/Telephone Switching Options
You specify these options when your Receive Mode is Fax/Telephone
Switching (FaxTel mode).
•
Listen Time Before Ringing
When a call is received, the MultiPASS checks to see if the call
is from a fax machine or a telephone. You use this option to set
the appropriate amount of time (0-30 seconds) to allow the
MultiPASS to check for the type of call. If your MultiPASS does
not have enough time to detect the fax tone, it assumes the call
is from a telephone.
•
Ring Time
When your MultiPASS is set to receive both fax and telephone
calls (FaxTel mode), it rings to inform you of an incoming
telephone call. You use this option to set the appropriate amount
of time (10-45 seconds) the MultiPASS will ring. If you do not
pick up the telephone within a certain amount of time, the
MultiPASS stops ringing.
•
Ring Tone
You set the tone of the ring.
MP L6000—USERS MANUAL/V000/12-97
Setup and Utilities
Desktop Manager