Emerson MODBUS 485 Power Supply User Manual


 
Modbus 485 and Modbus IP Protocols - Thermal Management Products
77 Liebert
®
IntelliSlot
®
Modbus/BACnet IP
HW/HG Hrs Exceeded 10087 1
Hum Hrs Exceeded 10088 1
Dehum Hrs Exceeded 10089 1
Network Failure 10091 1
No Connection W/Unit 10092 1
Unit(s) Disconnected 10093 1
Unit Code Missing 10094
Unit Code Mismatch 10095
Call Service 10096
Low Memory 1 10097
RAM / Battery Failure 10098
HCB not connected 10099
(Parallel Flash) Memory 1 Fail 10100
(Serial Flash) Memory 2 Fail 10101
Customer Input 1 10104
Customer Input 2 10105
Customer Input 3 10106
Customer Input 4 10107
Digital Scroll Compressor 1 Sensor Fail 10108
Digital Scroll Compressor 2 Sensor Fail 10109
Low Int Temperature 10110
High Ext Dewpoint 10111
Cabinet Temp Sensor Fail 10112
Cabinet Humidity Sensor Fail 10113
Ambient Temp Sensor Fail 10114
Comp 1 Short Cycle 10132
Comp 2 Short Cycle 10133
Reheat Lockout 10140
Humidifier Lockout 10141
Compressor(s) Lockout 10142
Fire Alarm 10148
Heaters Overheated 10149
Condenser 1 Failure 10150
Condenser 2 Failure 10151
Humidifier Cylinder Worn 10152
Heat Rej VFD 10153
Heat Rej TVSS 10154
Humidifier Low Amps 10155
FC Lockout 10156
Water Leak Sensor Fail 10157
Reference Document: ST100I&C PA Parameters and Events, Version 18.0
If the Scale column has a value for a Data Description, divide the Modbus value by the value in the Scale column to get the
scaled value.
1. Any non-recognized alarm code by current firmware received from the DS control will trigger this event.
Table 23 Liebert DS
and Liebert PeX
- Status and Coil (continued)
Controller Liebert iCOM
v3
Data Description
Status Coil
Number
of Bits Scale Notes / Units