Filter
Top Products
DISASSEMBLY AND ASSEMBLY
3.2.6.12 Pull Tractor Sensor Removal
Step 1: Remove the upper paper guide. (Refer to Section 3.2.6.8)
Step2: Disconnect the red 2-pin pull tractor sensor connector from the connector junction board
assembly.
Step 3: Remove the CP(S) (M2x14) screw securing the pull tractor sensor (a micro-switch type sensor) to
the left side frame and remove the sensor.
CP(S)(M2X14)
Pull Tractor Sensor
Platen Holder (Right)
Rev. A
3-45