Filter
Top Products
DFX-8500
1.2.12.4 Overlapping Multi-part Form
e bindings must not be too hard. And there should not be any spill
1.2.12.5 Perforation
l Weak horizontal and vertical perforations cause paper jams.
v The length ratio of the cut part and uncut part of perforations must be more than 3 to 1 and Less than 5
to 1 (Refer to Figure I-13.).
l Horizontal perforations must have an uncut part in each end of the paper (Refer to Figure l-14.).
l At the intersection of horizontal and vertical perforations, the cut part of the perforations must not cross
each other (Refer to Figure l-15.).
l The raised part at the perforation must bs less than 1 mm when the bottom layer kept by force (Refer
to Figure l-16.).
1.2.12.6 Notes
l Clean paper (with no folds, creases, tears) should be used (Refer to Figure l-17.).
l The sprocket hde must be circular. The hole may have teeth (Refer to Figure l-18.).
l The sprocket hole of each layer must not be shiied (Refer to Figure l-19.).
l The litter of sprocket holes must be removed from the paper.
l Paper should be fan-folded at horizontal perforations. Never use one that is not fan-folded property
(Refer to Figure l-20.).
. No hole is acceptable in the printable area.
. Paper must be tom off accurately along perforations.